10
Instructions Guide
DAB/DAB+ Radio
Fully extend the antenna (Ref.).
Press the ‘Mode’ button (Ref.) multiple times on the unit to switch to
DAB/DAB+ Radio. To select the mode from the remote, press the ‘FM/
DAB’ button (Rem.19).
On rst use when DAB Radio is activated for the rst time, a Full Station
Scan must be completed. Press the ‘Menu’ button (Rem.8/Ref.). Then,
use the ‘Enter/Play’ button (Rem.26) on the remote or press down the
Navigate/OK dial on the unit (Ref.) to select ‘Full Scan’.
This will start a scan up the frequency band and store all stations that
have a good signal. After searching has nished it will automatically
play the rst station stored.
To listen to all stations that have been stored use the ‘Next’ (Rem.25)
and ‘Previous’ buttons (Rem.10) to scroll through them.
When you turn on the radio again after it switching o, it will
automatically tune to the same station (DAB or FM) that was last
selected. In DAB/DAB+ mode, the radio will synchronize with the time
and date of the station.
EN
To Next Page
Loading...
