- 17 -
[1] Gimbal control operation interface
Displays the currently connected product name; click to enter the gimbal operation interface: you
can simulate the joystick, switch on the gimbal follow mode, manually adjust the roll angle, etc.
When not connected, you will be prompted to connect to the gimbal.
[2] Switch the connected device
Refresh the connected device or switch to connect to other compatible devices.
[3] Exit the current connection
Click to exit the currently connected gimbal.
[4] Trigger button settings
The trigger button function can be set as PTF/FPV/Lock/Fast follow.
[5] Joystick function settings
The joystick can be set to pan/tilt reverse, and pan/tilt speed.
[6] Follow speed settings
The follow speed can be set to slow/med/fast, or custom speed.
[7] Reset
Restore all settings to the factory defaults.
[8] Horizon calibration
Manual or auto calibration.
[9] Camera settings
You can set the camera aperture, shutter and ISO parameters.
[10] Motor power settings
The pan, tilt and roll power can be set, respectively, or you can click "Adapt" to adapt to the
motor power automatically.
If the camera is used for the rst time or has been replaced, adjust motor power
adaptation after power on.
[11] Timelapse
Timelapse can be set according to the waypoint. Adjust the gimbal to the angle you want and
click "+” to record the current waypoint. Up to 10 waypoints can be added. Smoothness/
Time/Frame rate/Interval can be set. Once the parameters have been set, tap the "Start
shooting" button to start shooting.
[12] Return
Return to the previous level.
To Next Page
Loading...
Need help?
General
