Manitou 180 ATJ 2 E3 RC - Page 131

3-19
B6/2
B6/3
B6  DRY AIR FILTER CARTRIDGE
CLEAN
If the machine is being used in a very dusty atmosphere, reduce these maintenance intervals
and see the FILTER ELEMENTS AND BELTS section.
- Open the left-hand cover.
- Locate the air filter1 (Fig. B6/1).
- Unclip the cover 2 (Fig. B6/2).
- Release the filter cartridge 3 (Fig. B6/3) by pulling it.
- Leave the safety filter 4 (Fig. B6/4) in place.
- Use a jet of compressed air to clean the filter cartridge, blowing only from the inside towards
the outside.
Observe the safety distance of 30 mm between the jet of air and the cartridge
to avoid tearing or pier
cing the cartridge. You must not blow out the cartridge
near the air filter casing. Never clean the cartridge by tapping it against a
hard surface. Protect your eyes during this operation.
- Clean the inside of the filter with a clean, damp, lint-free cloth.
- Check the condition of the filter car
tridge and replace it, if necessary.
- Refit the cartridge and the cover.
Never wash a dry air filter cartridge. You must not clean the safety cartridge
located inside the filter cartridge under an
y circumstances; replace it with a
new one if it is clogged or damaged.
B7  FUEL FILTER CARTRIDGE
REPLACE
- Open the left-hand cowl.
- Carefully clean the exterior of the filter and its
holder to prevent dust from entering the system.
- Close the fuel tap 1 (Fig. B7/1) to the OFF position.
- Unscrew the retaining ring 2, remove the
container 3 (Fig. B7/2) and clean the interior with
a paintbrush impregnated with clean diesel.
- Throw away the filter cartridge 4 (Fig. B7/2).
- Reinstall the assembly with a new filter (see 3
– MAINTENANCE: FILTER ELEMENTS AND BELTS
section).
B6/1
1
2
3
B6/4
4
B7/2
2
3
4
B7/1
1
647414 EN (27/05/2015)