Manitou 180 ATJ 2 E3 RC - Engine Fault Light; Preheating Indicator Light; Start-Up Control Button

2-43
25 - “PREHEATING” INDICATOR LIGHT
This indicator light illuminates when the machine is supplied with power:
- Either by turning the ignition key on the base (the timing is identical to that shown on
the bar graph on the screen).
- Or by rearming the Emergency Stop on the basket console in the lifting platform.
- Wait until the indicator light goes out before operating the starter button.
26 - START-UP CONTROL BUTTON
- Wait for the ”Preheating” light to go out and then press button 26 to start the lifting
platform from the basket console.
27 - “ENGINE FAULT” LIGHT
- This indicator light comes on and a short intermittent signal sounds.
- Descend quickly to the ground before automatic engine switch-off.
Problem:
- Engine oil pressure : 90 seconds before engine switch-off.
- Engine water temperature : 90 seconds before engine switch-off.
- Engine over-revving : Immediate engine switch-off.
- Stop the engine immediately.
677718
677718
25
26
27
647414 EN (27/05/2015)