Manitou 180 ATJ 2 E3 RC - Page 133

3-21
C2/1
C2/2
2
2
2
FRONT AXLE
REAR AXLE
C2  FRONT AND REAR AXLE OIL LEVEL
CHECK
For the 160 ATJ E3
Set the lifting platform on a horizontal surface with the engine switched off.
- Remove the level plug 2 (Fig. C2/1: front axle) (Fig. C2/2: rear axle), the oil level should be flush
with the hole.
- If necessary, top up the oil (See the LUBRICANTS section) via this hole.
- Refit and tighten the level plug 2 (Fig. C2/1: front axle) (Fig. C2/2: rear axle).
For the 160 ATJS E3:
- Remove the level plug 2 (Fig. C1/2: front axle) (Fig. C1/3: rear axle), the oil level should be flush
with the hole.
- If necessary, top up the oil (See the LUBRICANTS section) via this hole.
- Refit and tighten the level plug 2 (Fig. C1/2: front axle) (Fig. C1/3: rear axle) (tightening torque
6 daNm)
C1/2
C1/3
2
2
647414 EN (27/05/2015)