2 - 40
WATER IN FUEL PRE-FILTER LAMP
This lamp will come on when there is water in the fuel pre-filter. Stop the lift truck and carry out the necessary repairs
(see: 3 - MAINTENANCE: SERVICING SCHEDULE).
ENGINE AUTOMATIC PREHEATING LAMP
This lamp comes on when the lift truck's ignition is switched on and should go out as soon as pre-heating is ended. If it comes
on while the lift truck is in operation, immediately stop the engine and find the cause.
ENGINE OIL PRESSURE LAMP
If the lamp comes on when the lift truck is running, stop the engine immediately and look for the cause (see oil level in engine
crankcase).
NOTE: After starting the engine, the indicator lamp remains on for a few seconds then goes out when the correct engine
oil pressure is reached. The full engine power is then available.
ENGINE FAULT INDICATOR LAMP
If the lamp comes on when the lift truck is running, stop the engine immediately and look for the cause (possible leak, etc.).
NOTE: This lamp comes on the moment the ignition key is in position I and until the engine is started.
BATTERY LOAD LAMP
If this lamp comes on when the lift truck is running, switch off the engine immediately and check the electric circuit and the
alternator belt.
GREEN PROGRESSIVE INCHING TRANSMISSION MODE INDICATOR LAMP (OPTION)
This lamp comes on when using the progressive transmission “INCHING” mode (see: 2 - DESCRIPTION: 6C - PANEL FOR BUTTONS
AND KEYBOARD).
GEAR BOX OIL PRESSURE LAMP
This lamp comes on when there is an abnormal drop in gear box pressure. Stop the lift truck and look for the cause (e.g., Low oil
level in the transmission, internal leak in the transmission, etc.).
GEAR BOX OIL TEMPERATURE LAMP
This lamp comes on when the temperature of the gear box oil is abnormally high. In this case, place the forward/reverse
selector in neutral and let the engine running at idle for a few minutes. If the lamp remains on, stop the lift truck and contact
your dealer.
NOTE: Abnormal heating of the oil may be linked to an incorrect use of the gear box ratios (see: 2 - DESCRIPTION: 20 -
GEAR LEVER).
PARKING BRAKE LAMP
This lamp comes on when the parking brake is applied.
A flashing lamp indicates a fault (see: 2 - DESCRIPTION: 6D - SCREEN DISPLAY: MENU SCREEN).
HYDRAULIC MOVEMENT NEUTRALISATION LAMP
The lamp lights when the hydraulic controls are neutralised and when a forbidden hydraulic movement is requested.
NOTE: When driving on the road, it is highly recommended that you lock all the hydraulic movements
647104 (13/06/2016)
MT 835 / 1135 / 1335 ST3B
To Next Page
Loading...
Need help?
General
