Manitou MT 835 ST3B User Manual

2 - 45
RESETTING THE DAILY WORKING HOURS COUNTER BACK TO ZERO
- Reset the daily hour counter to zero from the XPRT menu in the menu screen.
NOTE: Authorization of this function can be configured from the OPT menu in the menu screen.
RESETTING THE MAINTENANCE COUNTER TO 500H
- Reset the maintenance counter to 500h from the XPRT menu in the menu screen.
NOTE: The hour meter screen can be displayed as required from the operating screen by means of the button
.
OPERATING SCREEN
The screen displays the lift truck's operating state (different screen for each operating mode).
LIFT TRUCK ON TIRES
1
Blank screen.
If no function is unlocked and at least one function is locked
(see fault screen).
If at least one function is unlocked (see fault screen).
2
Blank screen.
Attachment circuit unlocked.
Flashing screen.
Attachment circuit in requested continuous mode disabled.
Steady screen.
Attachment circuit in continuous mode enabled.
3
Blank screen.
4
Boom lifting angle in degrees.
Lifting angle sensor fault
(contact your dealer).
5
Blank screen.
Maintenance key.
6
Blank screen.
Automatic exhaust particle filter regeneration disabled (see:
8 - SWITCHES).
High or very high soot level
(see: 8- SWITCHES).
7
Blank screen.
Transmission locked in neutral, driver presence not validated.
OPTION Progressive INCHING transmission mode in forward
and reverse gear.
8
Lift truck speed in km/h.
Lift truck speed sensor fault (contact your dealer).
LIFT TRUCK ON STABILISERS
MT 1135 ST3B / MT 1335 ST3B
1
Blank screen.
If no function is unlocked and at least one function is locked
(see fault screen).
If at least one function is unlocked (see fault screen).
2
Blank screen.
3
Blank screen.
4
Boom lifting angle in degrees.
Lifting angle sensor fault (contact your dealer).
5
Blank screen.
Maintenance key.
6
Blank screen.
Automatic exhaust particle filter regeneration disabled (see:
8 - SWITCHES).
High or very high soot level (see: 8- SWITCHES).
7
Blank screen.
Attachment circuit unlocked.
Flashing screen.
Attachment circuit in requested continuous mode disabled.
Steady screen.
Attachment circuit in continuous mode enabled.
Blocked rear axle oscillation.
Blocked rear axle oscillation fault + + audible beep.
8
Stabilisers resting on the ground and
under pressure.
To validate the
information, the last
movement of the
stabiliser must be
lowering.
Left stabiliser resting on the ground
and under pressure.
Right stabilisers resting on the
ground and under pressure.
647104 (13/06/2016) MT 835 / 1135 / 1335 ST3B

Manitou MT 835 ST3B Specifications

General

Brand	Manitou
Model	MT 835 ST3B
Category	Front End Loaders
Language	English