2-71
RT765E-2 SERVICE MANUAL HYDRAULIC SYSTEM
Published 9-04-2014, Control # 422-08
13. Clean all oil from the threads of the cylinder head and
apply Loctite #290 to the threads.
14. Slide the rod assembly into the cylinder barrel and screw
the cylinder head into the barrel.
15. Coat the threads of the 5/8 inch capscrew with Loctite
#290. Install the rod end plate and secure the plate to
the inner rod end with the 5/8 inch capscrew and
washer. Torque the capscrew 144 to 156 lb-ft (195
to211 Nm).
16. Secure the rod retaining plate to the cylinder barrel with
the 7/16 inch capscrews and washers. Torque the
capscrews to 48 to 52 lb-ft (65 to 70 Nm).
17. Pressurize and cycle the cylinder with hydraulic oil
pressure. Test the cylinder at 5250 psi (36,170 kPa).
Check for proper operation and any leakage. Make
repairs as needed.
CAUTION
Do not use air pressure to cycle or pressurize the cylinder.
Damage to the seals may result.
Reference Only
To Next Page
Loading...
