Manitowoc Indigo Series - Ice Beverage Ice Machines

60 Part Number Preliminary 6/11
Ice Beverage Ice Machines
A. Remove splash shield
• Grasp the top center of splash shields.
• Lift up and then out.
B. Remove ice thickness probe
• Compress the hinge pin on the top of the ice
thickness probe.
• Pivot the ice thickness probe to disengage one pin
then the other. The ice thickness probe can be
cleaned at this point without complete removal. If
complete removal is desired, disconnect the ice
thickness control wiring from the control board.
A
B
C
D
E