Mankati FULLSCALE XT PLUS - Page 53

www.mankati.com
51
How to deal with issues of “faulty distance between
nozzle & plate”?
How to deal with
issues of “build plate
still inclines or faulty
distance between
nozzle&plate after
plateleveling”?
How To
Loosen the screws and
raise the Z limit stopper
on rear side a little
higher..
How to print with double colors in one object?
1. Load the model into
MankatiUM, and then
right-click model,choose
"Dual extrusion merge"
2. Then you can set
parameters for the main
nozzleandvicenozzle.