Marantz SR4023 - Remote Control Integration; Connecting Marantz Components

ENGLISH
CONNECTING THE REMOTE CONTROL JACKS
=
E
@
'--::=-----==------------~-
6
REMOTE
CONTROL
IN@
OUT@
CD
You can control other Marantz products through
this unit with the remote control by connecting the
REMOTE CONTROL terminals
on each unit.
The signal transmitted from the remote control is
received
by the remote sensor on this unit. Then the
signal
is sent to the connected device through this
terminal. Therefore you only need to aim the remote
at one unit. Also, if a Marantz power amplifier (some
models excluded) is connected to one of these
terminals, the power amplifier's, power switch is
synchronized with this unit's power switch.
Set the REMOTE CONTROL SWITCH on the units,
other than the main unit to EXT.(EXTERNAL) for this
feature.
o
Wheneverexternal infrared sensors or similardevices
are connected to RC-5
IN of the SR4023, be sure to
always disable operation of the infrared sensor on the
main unit by using the following procedure.
1. Hold down the S-DIRECT button and BAND
button on the front panel at the same time for 3
seconds.
2. The setting "IR=ENABLE" is shown on the FL
DISPLAY.
3. Press TUNING/PRESET .. or 'Y button to
change this
to "IR=DISABLE".
4. Press the MUTE button. Once this setting is
made, the infrared sensor
on the main unit is
disabled.
Note:
Be sure to set to "IR=ENABLE" when external
infrared sensors or similardevices are not connected.
Otherwise, the main unit will be unable to receive
remote control commands.
5. To restore the original setting, perform steps 1
to 4
to set to "IR=ENABLE".