Marantz SR6005 - Playing an Ipod

25
Simple version Advanced version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Basic version
Playing an iPod
®
You can play back audio only.
1
Connect the iPod
®
to the USB
port (vpage 19 “Connecting an
iPod or USB memory device to
the USB port”).
2
Press ON to turn on power to the
unit.
3
Press NET/USB twice to switch
the input source to “USB/iPod”.
NOTE
If the connections screen is not displayed,
the iPod may not be properly connected.
Reconnect it.
4
Press SEARCH/INFO and hold it down for 2 seconds
or more to select the display mode.
• There are two modes for displaying the contents recorded on the
iPod.
Remote mode
Display iPod information on the TV screen.
• The unit display shows single-byte
alphanumeric characters and some
symbols only. “.” is displayed in place
of incompatible characters.
• In ”Remote mode”, the iPod display is
as shown at right.
OK to disconnect.
Direct mode
Display iPod information on the iPod screen.
• “Direct iPod” is displayed on the display of this unit.
Display mode
Remote mode Direct mode
Playable
files
Music file
P P
Video file
z
Active
buttons
Remote
control unit
(This unit)
P P
iPod
®
P
zOnly the sound is played.
5
Use ui to select the item, then press ENTER or p
to select the le to be played.
6
Press ENTER, p or 1.
Playback starts.
• You can specify the duration of the on-screen display to be displayed
(default: 30 sec) at menu “USB/iPod” (vpage66). Press uio p
to return to the original screen.
• To play back compressed audio with extended bass or treble
reproduction, we recommend playback in M-DAX mode (vpage59).
The default setting is “OFF”.
• In Remote mode, press STATUS during playback
to check the title name, artist name, and album
name.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• Note that Marantz will accept no responsibility whatsoever for any
problems arising with the data on an iPod when using this unit in
conjunction with the iPod.