3.9. TUNER STEP mode (N only)
3.9.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.9.2. Starting up
Hold down buttons "
ZONE SELECT
" and "
BACK
" at the same time and press the power button to turn on the power.
Select the
"5. TUNER FRQ SET"
using the button "
CURSOR
f
/
d
", and press the button "
ENTER
" to commit the selec-
tion.
3.9.3. Displays
Start this unit in TUNER STEP mode, select using button "
CURSOR
0
/
1
" and enter using button "
ENTER
".
The following information is displayed in the following order.
(1) AM9kHz/FM50kHz selected
FLD
L1
* T U N E R F R Q S e t
L2
< A M 9 / F M 5 0 >
"
CURSOR
0
" "
CURSOR
1
"
(2) AM10kHz/FM200kHz selected
FLD L2
< A M 1 0 / F M 2 0 0 >
"
ENTER
"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
4. Protection Pass Mode
4.1. Actions
• This mode allows the power to be turned on without activating protections.
• This is the same as normal power-on, except that protections are not activated.
4.2. Operations
Hold down buttons "
M-DAX
", "
DYNAMIC EQ
" and "
DYNAMIC VOL
" at the same time and press the power button to
turn on the power.
The device returns to the normal display after the following is displayed.
FLD L1
P r o t e c t i o n P a s s
This is displayed for 5 seconds before returning to the normal display.
78
To Next Page
Loading...
