Marantz SR7009/U1B - Technical Specifications

n
Audio section
• Power amplifier
Rated output:
Front:
125 W + 125 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.)
165 W + 165 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center:
125 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.)
165 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround:
125 W + 125 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.)
165 W + 165 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround back / Front height / Front wide:
125 W + 125 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.05 % T.H.D.)
165 W + 165 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Output connectors:
4 – 16 Ω/ohms
• Analog
Input sensitivity/Input impedance:
200 mV/47 kΩ/kohms
Frequency response:
10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
S/N :
100 dB (IHF–A weighted, DIRECT mode)
Distortion :
0.005 % (20 Hz – 20 kHz) (DIRECT mode)
Rated output :
1.2 V
• Digital
D/A output :
Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.008 % (1 kHz, at 0 dB)
S/N ratio — 102 dB
Dynamic range — 100 dB
Digital input :
Format — Digital audio interface
• Phono equalizer (PHONO input — MEDIA PLAYER OUT)
Input sensitivity :
2.5 mV
RIAA deviation :
±1 dB (20 Hz to 20 kHz)
S/N :
74 dB (A weighting, with 5 mV input)
Rated output :
150 mV
Distortion factor :
0.03 % (1 kHz, 3 V)
n
Video section
• Standard video connectors
Input/output level and impedance :
1 Vp-p, 75 Ω/ohms
Frequency response :
5 Hz – 10 MHz — 0, –3 dB
• Color component video connector
Input/output level
and impedance:
Y signal — 1 Vp-p, 75 Ω/ohms
PB / CB signal — 0.7 Vp-p, 75 Ω/ohms
PR / CR signal — 0.7 Vp-p, 75 Ω/ohms
Frequency response:
5 Hz – 60 MHz — 0, –3 dB
n
Tuner section
(Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10
–15
W)
Receiving Range : FM 87.5 MHz - 107.9 MHz(for U)
FM 87.5 MHz - 108.0 MHz(for N, K)
FM 76.0 MHz - 90.0 MHz(for F)
AM 520 kHz - 1710 kHz(for U)
AM 522 kHz - 1611 kHz(for N, K)
AM 522 kHz - 1629 kHz(for F)
Receiving Range : FM 1.5μV(14.8dBf)(for U)
FM 1.2μV(12.8dBf)(for N, K, F)
AM 20 μV(for U)
AM 18 μV(for N, K, F)
S/N (IHF–A weighted) : MONO ― 78 dB (for U)
MONO ― 70 dB (for N, K, F)
STEREO ― 68 dB (for U)
STEREO ― 67 dB (for N, K, F)
HD ― 85 dB (for U)
Distortion (1 kHz) : MONO ― 0.1 % (for U)
MONO ― 0.7 % (for N, K, F)
SRETEO ― 0.2 % (for U)
SRETEO ― 1.0 % (for N, K, F)
HD ― 0.02 % (for U)
n
Wireless LAN section
Network type
(wireless LAN standard): Conforming to Wi-Fi®z1
Security : WEP 64 bit, WEP 128 bit
WPA/WPA2-PSK (AES)
WPA/WPA2-PSK (TKIP)
Radio frequency : 2.4 GHz
No. of channels : 1 - 11 ch (for U)
1 - 13 ch (for N, K, F)
z1 The Wi-Fi® CERTIFIED Logo and the Wi-Fi CERTIFIED On-
Product Logo are registered trademarks of the Wi-Fi Alliance.
n
Bluetooth section
Communications system : Bluetooth Version 2.1 + EDR
(Enhanced Data Rate)
Transmission power : Maximum 2.5 mW (Class 2)
Maximum communication range : Approx. 32.8 ft/10 m in line of sight
Frequency band : 2.4 GHz band
Modulation scheme : FHSS (Frequency-Hopping Spread Spectrum)
Supported proles : A2DP 1.2 (Advanced Audio Distribution Prole)
AVRCP 1.4 (Audio Video Remote Control Prole)
Corresponding codec : SBC, AAC
Transmission range (A2DP) : 20 Hz - 20,000 Hz
n
General
Power suppl : (for U) : AC 120 V, 60 Hz
(for N) : AC 230 V, 50 Hz / 60Hz
(for K) : AC 220 V, 50 Hz
(for F) : AC 100V, 50/60Hz
Power consumption:
710 W
Power consumption in standby mode:
0.2 W
Power consumption in CEC standby mode:
0.5 W
Power consumption in network standby mode:
2.7 W
For purposes of improvement, specications and design are subject to
change without notice.
TECHNICAL SPECIFICATIONS
9