Installation manual - Ecotype - 11
2.4 Installation of the optional idler pulley system
If linearity between the cabin guard and the top edge of the sides is not possible (pic. A) you can proceed as follows:
Request to Marcolin Covering s.r.l. an optional idler pulley system (pic. B).
The optional idler system allows to deflect the steel cable from the top edge of the cab
guard to the top edge level of the side walls in order to obtain a linear sliding movement of
the covering.
Obviously, in this case, the covering occupies a part of the tipper body and the tarpaulin
must be fastened over the cab guard.
Another solution is fastening the front boxes at the level of the side edge and, to prevent the front steel cables from
hitting the cylinder or spare tyre bracket, creating deflections with pulleys (pic. C), so that the steel cable passes very
close to the frontal sideboard.
To Next Page
Loading...