52 - Installation manual - Ecotype
5.4.8 Replacement of broken or damaged fastening hooks on the outer board wall (only when the
components are present)
• Replace the hooks at the first sign of wear and tear.
5.4.9 Lubricate and grease thoroughly the covering system
1) GREASE THE INTERNAL COUPLING BETWEEN
PINION AND GEAR (hand-operated version)
Make use of lithium-based grease.
CLEAN AND LUBRICATE THE VARIOUS PULLEYS LOCATED ON THE MACHINE,
CABLES, GROOVES AND SLOTS OF THE PULLEYS, BY APPLYING SVITOL® or WD-40
LUBRICATING OIL OR A SIMILAR PRODUCT.
5.4.10 Filling in the machine control register
The manual handed over to the customer includes a chapter referred to as “Control register”.
The Control register MUST ALWAYS BE fulfilled, completed with a report and duly signed by the firm that carried out the
extraordinary maintenance work on the machine.
In the event of a legal dispute the lack of the necessary entries in the Control register of the customer’s
machine could also implicate for you an involvement in civil and criminal objective liability.
To Next Page
Loading...