Installation manual - Ecotype - 47
4.3.3 Installing hooks and side guides
For installation, proceed as described below:
1. Unfold the covering to cover the body entirely.
2. Determine where to fix the hooks.
1. Place the hook support (2) on the side of the support foot bracket (1).
2. Secure the bracket to the support using the round head screws (3) provided.
Use medium-strength Loxeal 54.03 thread locking fluid on the round head screws (3) provided.
3. Secure the hook to the support using the hex bolt (4) and the self-locking nut (5) provided.
Leave a minimum clearance of 1 mm between the nut and the side plate of the hook.
After determining the height of the hooks, you can install the Z-section
guides on both sides of the body.
The standard size of the Z-section guide is 30x30x3 mm.
Different sizes could jeopardize the correct operation of the
anchoring system and damage the covering tarpaulin.
4. Place the Z-section guide (7) at approx. 8 mm from the top of the hook
tip, as show in figure. ā
The installation position of the Z-section guide is the same with both
normal and lowered cables.
To Next Page
Loading...