MARCOLIN Ecotype - Page 34

34 - Installation manual - Ecotype
Once the main components are fastened, proceed with wiring the system.
WARNING!
The electrical system must be installed by qualified personnel!
Disconnect the battery to remove voltage from the system before proceeding with the electrical
connections.
Loc.
Description
1
Power Supply – 24 V
2
Power Supply + 24 V
3-4
Connection to motor
Note: Verify the correct direction
of rotation of the motor using the
controls at loc. 7. If, when you
turn the selector to
"UNCOVERED", the tarp covers
the body instead of uncovering
it, reverse the polarity of the
motor contacts.
5
INPUT - Retraction board
control
6
OUTPUT - Motorised vibrator
control (MAX - 5 A)
Warning: negative output!
7
Latching control selector
(UNCOVERED / COVERED)
8
“TX MARCOLIN” radio
remote control programming
button
1. By use of the supplied cables connect the battery to the power supplying terminals (1-2) of the Control Box.