EN
11
5.0 Change settings
5.1 Call user menu
To activate the users menu:
•
You push the OK button.
•
After which you enter the correct Pin code according to the image below
(standard factory setting is 1000).
selectmodify
User Menu
Clock Program
Special day
Settings
Temperature
OK
ES
SC
2x
OK
factory default
menu code
1 0 0 0
User Menu
18.0 °C
01-03-2011
08:10
0.21
Code 0000
OK
na 4x
to next digit
•
with the and button you change the ashing gure.
•
you conrm this with the OK button and you jump to the next gure. After you push on
the OK button at the 4th gure and you enter the correct pin code, you enter the user
menu and you can change the temperature setting, the switch times, the exception days and
all the other settings.
When an incorrect pin code is entered the screen image pin code input remains visible and the
code jumps back to 0000.
Note!
When no button is pressed for the duration of 1 minute the OptiTherm+ display will
automatically leave the menu and go back to the main display.
5.2 User menu: change the temperature setting
To change the temperature setting you follow the images below:
User Menu
Clock Program
Special day
Settings
Temperature
OK OK
ESC ESCESC
back to main screen
selectmodify
Temperature
Eco
Night
Frost
Day
5.0 °C
8,0 °C
15,0 °C
18,0 °C
Temperature
Eco
Night
Frost
Day
5.0°C
8,0°C
15,0°C
18,0°C
•
In the user menu select the menu-item temperature and then push the OK push-button.
•
With the and button, select the mode of operation which you wish to change and
conrm this with the OK button.
•
The display jumps to the temperature setting of the chosen mode of operation. With
the and button, change the temperature setting and conrm this with the OK button.
Follow the steps above to change the other temperature settings.
When you are nished with changing the temperature settings:
•
After the last change you press the OK button to conrm this.
•
Then you push the ESC button to go back to the user menu again.
To Next Page
Loading...
