Mark OptiTherm Plus 06 29 189 - Initial Operation Procedure

3.5 First initial operation
•
Connect the electricity supply again once the mounting and installation of the OptiTherm+
and air heaters has been completed. For this, also consult the technical manual of the air
heaters.
After you have connected the electricity supply the OptiTherm+ display will light up and ask you:
1. To select the correct language.
2. To enter the correct data and time.
For this, follow the image below:
OK
modify
OK
OK
to next digit
Language
Nederlands
Deutsch
Français
English
English
Date/Time
Date
Time
--201101 03
08:00
5.0 °C
01-03-2011
08:30
0.21
modify
•
Select with the  and  button, the desired language and conrm this with the OK button.
•
The display now automatically jumps to the date setting. Now change the day, month and
year, in that order with the  and  button. Conrm each entry with the OK button after
which the display automatically goes to the following entry. After you have changed the
year, the display will automatically go to the time settings.
•
Now change the hours and minutes, in that order with the  and  button. Conrm each
entry with the OK button after which the display goes automatically to the following entry.
•
After the minutes are lled in the main screen will be shown on the display and the
OptiTherm+ is ready for use.
For further explanation see the sequence of this technical manual.
– For the operation and explanation of the display and the buttons, see §4.0 Operation.
– For changing the settings see §5.0.
– For the Messages and Malfunctions see §6.0.
7
EN