T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com
www.markes.com
The Carrier Gas being used can be set using the drop down box.
NOTE: Carrier type only needs to be set when using MFCs.
The carrier gas pressure as measured by the pressure transducer, within the UNITY 2, can be displayed in
either psi or kPa depending upon preference, and is selected here.
3.4.4 Methods
This is accessed by selecting ‘View > Options > Methods’. There are two method functions which can be
changed.
To Next Page
Loading...
