Step 3
Remote Feature Programming
Use the transmitter buttons as illustrated to adjust the features required. Keep repressing the transmitter button that
relates to the feature you want to adjust until the correct amount of chirps/beeps is heard. Move on to the next feature.
One Chirp /
Two Chirps / Three Chirps / Four Chirps /
Button LED One Pulse
LED Two Pulse LED Three Pulse LED Four Pulse
(Factory Default Setting)
Parking Light “On” for
30 Seconds Upon an
Unlock Signal
0.8 Second
Door Lock Pulses
0.6 Second
Door Lock Pulses
3.5 Second
Door Lock Pulse
Ignition Controlled
Door Lock Only
Ignition Controlled
Door Unlock Only
Ignition Controlled
Door Lock and Unlock
Without Ignition Controlled
Door Lock and Unlock
The Vehicle is
without Turbo
(The System Can Not
be Armed with the
Engine Running)
The Shock Sensor will be
Bypassed as Long as the
Engine is Running
Pathway Illumination
Feature “Off”
The Shock Sensor will be
Bypassed for 1 Minute
Door Lock with “Comfort
Feature” See Note Below
Parking Light “On” for 30
Seconds Upon Disarm
and 10 Second Upon Arm
Disables the Out-of-
Range Check
+
Enables the Out-of-
Range Check
ON
Turn On the Ignition
3 long chirps and 3 flashes of the
parking lights will confirm exit of
the programming mode.
Note: Waiting 15 seconds after the
last command will also cause the
system to automatically exit the
programming mode.
Step 4: Exit Program Mode
the Shock Sensor will be
Bypassed for 3 Minutes
Comfort Feature:
Some vehicles have a special “Comfort Feature”. When you lock the door with the key, you have to hold the key in
the lock position for about 5 to 7 seconds and the windows will close automatically. If you wish the vehicle’s
Comfort Feature to be activated when you remotely lock the doors, program Door Lock with Comfort Feature “ON”.
5 Chirps = 0.8 Second Double Pulse Unlock
6 Chirps = 0.6 Second Double Pulse Unlock
The Vehicle has Aftermarket Turbo Timer Installed.
(The System Can be Armed with the Engine Running and . . .)
3X
Step 1
3X + 1X (Hold)
Before 15 seconds has passed, push and release the
valet switch 4 times. Hold the button down on the 4th
press until 2 short chirps/beeps and 1 long chirp/beep
is heard then release it. You are now in “Alarm Feature
Programming (Group 2)” mode.
Step 2
With the ignition switch in the OFF position, turn the
key On-Off-On-Off-On-Off
16
Alarm Feature Programming (Group 2)
X4-IM.qxp 3/6/08 10:53 AM Page 16
To Next Page
Loading...
