30 MAC 2000 Profile
C
ONTROL
MENU
Menu Item Options Notes (Default settings in bold print)
AddR - 1-512
DMX address
PSET -
8bit
Full control with coarse pan, tilt, and gobo indexing
16bt
Full control with fine pan, tilt, and gobo indexing
PATI
SWAP
ON
Map DMX pan control to tilt channel and vice versa.
OFF
Normal pan and tilt control
PINV
ON
Reverse DMX pan control, right ! left
OFF
Normal pan control, left ! right
TINV
ON
Reverse DMX tilt control, down ! up
OFF
Normal tilt control, up ! down
PTSP -
NORM
Medium pan/tilt speed
FAST
Optimize movement for speed
SLOW
Optimize movement for smoothness
Stud -
OFF
Optimize effects for speed
ON
Optimize effects for silence
PERS
dISP
ON
Display remains on
OFF
Display extinguishes 2 minutes after last key press
dINT 10-100
Adjust display intensity
dLOF
ON
Enable DMX lamp off command
OFF
Disable DMX lamp off command
dRES
ON
Enable DMX reset command
OFF
Disable DMX reset command
ALON
ON
Lamp strikes automatically within 90 seconds of power on
OFF
No automatic lamp strike
dMX
Lamp strikes if DMX is present, douses 15 mins. after it’s missing
SCUT
ON
Color, gobo, and effect wheels turn shortest distance
OFF
Color, gobo, and effect wheel paths oscillate
TRAC
MOdE
MOd1: Absolute delta value algorithm (for most controllers)
moD2: Real delta value algorithm
CAL
1-10.
Tracking samples. Increase if pan/tilt is not smooth.
(Default = 6)
CSPd
NORM
Normal color/gobo wheel speed.
FAST
Increases gobo/color wheel acceleration to maximum and provides
faster color bumps. Note that gobo/color wheel step loss my occur
under low power or high temperature conditions that decrease
motor torque. The NORM option is slower, but less prone to step
loss.
dFSE
FACT LOAD
Return all personality settings (not calibrations) to factory defaults
CUS1,CUS2,
CUS3
LOAd
Load custom configuration
SAVE
Save current configuration
Table 6: Control menu
To Next Page
Loading...
Need help?
General
