Martin MAC 250+ User Manual

4
MAC
250 and
MAC
250
+
section 2
SETUP
Unpacking
The MAC 250 and MAC 250
+
come with:
• 1 1/4-turn clamp mounting bracket
• 1 5-meter, 3-pin shielded XLR control cable
• 1 3-meter, 3-wire IEC power cable
• 1 user manual
The packing material is carefully designed to protect the fixture during shipment - always use it or a custom flight case
to transport the fixture.
Lamp installation
Compatible lamps
The lamps listed in the table below may be used with the MAC 250 and MAC 250
+
. Installing any other lamp may
damage the fixture.
WARNING!
Disconnect the fixture from AC power and allow the lamp to cool for at least 5
minutes before proceeding. Wear safety goggles to protect your eyes.
Lamp Replace before Average life Color Temp. Output P/N
Osram HSD 250 2500 hr 2000 hr 6000K 68 lm/W 97010103
Philips MSD 250/2 2200 hr 2000 hr 6500K 72 lm/W 97010100
Philips MSD 200 2200 hr 2000 hr 5600K 67 lm/W 97010106
Figure 1: Lamp installation
reflector alignment screws
lamp socket assembly

Martin MAC 250+ Specifications

General

Type	Moving Head
Pan	540°
Control	DMX512
Color Wheel	dichroic filters
Gobo Wheel	6 interchangeable rotating gobos + open
Focus	Motorized
Prism	3-facet, rotating
Effects	Strobe