User Manual 13
Readouts
Usage readouts (TIME)
Read the total number of power-on hours (Po H), power-on hours since last reset (RPoH), total lamp hours (LA H), lamp
hours since last reset (
RLAH), total number of lamp strikes (LSTR), and the number of lamp strikes since last reset (RLST).
The resettable counters may be used to track overall usage and lamp life. To reset to zero, display the readout and then press
[↑] for 5 seconds.
DMX value readouts (dMXL)
Read the DMX start code (STCO) and DMX values received for each channel. This is an easy way to check that the start code
is 0 and that the fixture is receiving the expected commands.
If the fixture is set to a DMX mode where some or all of the channels between 10 and 13 are not used, the readout on these
channels will be
N/A. Note: the channel number is 1 less in the readout than it is in the DMX protocol.
Software version readouts (VER)
Read the version number of the CPU software (CPU), pan/tilt feedback circuit (FEbA), and display module software
(
dISP). The CPU software version is also displayed for a moment at power up.
Temperature readouts (SPEC/ TEMP)
Read temperature in the base (bASE) and head (HEAd) in Celsius. Temperatures below 25° C are shown as -25; tempera-
tures above 100° C are shown as
+100.
The temperature sensors are calibrated at the factory and adjustment should not be necessary. The following procedure cali-
brates the sensors if they give no or faulty readings.
1. Allow the unit to cool to room temperature (powered off for at least 4 hours).
2. Measure the room temperature in Celsius. (To convert F° to C°, subtract 32° and then multiply by
0.555.)
3. Power up the unit and allow it to reset.
4. Press the [MENU] and [↓] keys at the same time and hold them for 3 seconds until “25” shows in the
display.
5. Press the [↑] and [↓] keys until the display shows the temperature measured.
6. Press [ENTER] to save the setting.
Manual control
Manual control (MAN)
The manual control menu permits you to do the following without a controller:
• reset the fixture (
RST)
• turn the lamp on and off (L ON, LoFF)
• open, close, and strobe the shutter at 3 speeds (SHUT)
• control the dimmer (
dIM)
• control the CMY wheels (CYAN, YEL, MAG)
• move the color wheel to each position (COL)
• control both beam shapers (BS1, BS2)
• control pan and tilt (PAN, TILT)
To Next Page
Loading...
