32 MAC TW1 user manual
Control panel shortcuts
The following shortcuts are available using the buttons in the MAC TW1 control panel:
To access
this menu,
hold
[Enter]
pressed for
a few
seconds
Enable pan/tilt position feedback/correction system. See
page 19
Disable pan/tilt feedback. Setting not saved
Enable CMY filter position feedback/correction system. See
page 19
Disable CMY filter position feedback. Setting not saved
Effects adjustment menu (for service use: see “Adjustment
submenu” on page 33)
(OF = offset)
Pan calibration (adjustment range: 1 - 255)
Tilt calibration (adjustment range: 70 - 186)
Cyan calibration (adjustment range: 1 - 255)
Magenta calibration (adjustment range: 1 - 255)
Yellow calibration (adjustment range: 1 - 255)
Zoom calibration (adjustment range: 98 - 158)
Load factory effects calibration settings
PCB test: for service use only
Cooling fans: full speed
Cooling fan speed temperature-regulated
Cooling fans: off whenever possible
Manually set fixture to software update mode
Shortcut Function
Hold [Menu] and press [Up] Resets fixture
Hold [Menu] and [Enter] during fixture reset Freezes pan and tilt
Hold [Up] and press [Down] Invert display
Table 4: Control panel shortcuts
Menu Item Options Notes (Default settings in bold print)
Table 3: Control menu
To Next Page
Loading...
Need help?
General
