USE AND MAINTENANCE
ENGLISH
Cod. F07022163
pag.59
9.8.4_ADJUSTING THE PICK-UP CAM
Adjust the position where the product is released from the pick-up tine by moving the cam located on the right
side of the pick-up
WARNING!
Stop the tractor, remove the keys from the dashboard and wait for all the
moving parts of the machine to stop completely.
Switch off the control system.
1) Loosen the screws and remove the safety guard placed on the right side of the pick-up.
2) Loosen the four screws “V” that hold the cam.
1
2
Adjust the position of the cam, rotating it so as to
move the pick-up tine nearer or further from the
transport assembly.
Rotate the cam towards the position:
“A” = to move the tine nearer to the collection unit.
“B” = to move the tine away from the collection unit.
After adjusting, tighten the two screws “V”.
Replace the guard and secure it with the screws.
V
A
B
A
B
To Next Page
Loading...
