Maschio TERMINATOR - Troubleshooting Guide; Demolition and Disposal

Code F07011709
USE AND MAINTENANCE
ENGLISH
31
5.2 PROBLEMS, CAUSES AND SOLUTIONS
INCONVENIENCE CAUSE REMEDY
Excessive vibration.
1) Breakage or excessive wear of blades and ham-
mers.
2) Blades or hammers blocked on pin.
3) Inadequate balancing of rotor.
4) Wear of rotor bearings.
1) Replace the worn or cracked pieces.
2) Clean and grease the pins.
3) Check the weight of the of the blades/hammers
block
4) Remove and replace bearings and seals.
Imperfect cut due to lower-
ing of engine speed.
1) Belt tension insucient.
2) Belts excessively worn.
1) Regulate tension.
2) Replace belts.
Overheating of belts.
1) Incorrect tension of belts.
2) Transmission axis and rotor axis out of alignment.
1) Check tension.
2) Check alignment.
Overheating of bevel gear
pair.
1) Lack of oil.
2) Oil depleted..
1) Add oil to proper level.
2) Replace
Rapid wearing of blades or
hammers.
1) Work position too low, blades touching ground. 1) Adjust height of rotor from ground.
Loss of oil from transmis-
sion, belt side.
1) Wear and breakage of oil seal..
1) Replace seal.
Deformation of the sup-
ports of the roller or wheels.
1) The supports of the roller and the wheels have un-
dergone side stress.
1) Raise the machine from the ground when in re-
verse gear.
Deformation of protective
guards.
1) In order to assume the work position, the machine -
from a raised position (transport) - has been lowered
onto the material to be shredded
.
1) The machine must be in the work position before
touching the material to be shredded.
6.0 DEMOLITION AND DISPOSAL
This operation is to be carried out by the customer.
Before demolishing the machine, you are advised to carefully check its physical condition and ascertain whether there are
any parts of the structure that may be susceptible to structural collapse or breakage during demolition.
The customer should operate in compliance with the environment protection laws in force in his/her country.
CAUTION
The machine demolition operations should be carried out by skilled personnel only, equipped with suitable pro-
tective clothing (safety footwear and gloves) and auxiliary tools and equipment. All the disassembly operations
for demolition should be carried out with the machine stopped and detached from the tractor.
Before demolishing the machine, you are advised to render harmless all the parts that may be a source of danger and
therefore:
- scrap the structure using specialized rms,
- remove any electrical apparatus according to the laws in force,
- collect oils and greases separately, to be disposed of through specialized rms, in accordance with the regulations of
the country in which the machine was used.
Finally, we remind you that the manufacturer is always available for any and all necessary assistance and spares.