Mase Generators IS 6.1 User Manual

IS 6.1
- 19
GB
GB
555
[21.85"]
650
[25.57"]
468
[18.43"]
505
[19.90"]
465
[18.31"]
521
[20.51"]
537
[21.14"]
56.5
[2.22"]
56.5
[2.22"]
405
[15.94"]
50
[1.98"]
50
[1.98"]
619
[24.37"]
15.5
[0.61"]
15.5
[0.61"]
Ø
1
4
[ Ø
0
.
5
5
"
]
Ø
9
[
Ø
0
.
3
5
"
]
1
2
3
mm
[in.]
3 INSTALLATION
The generator may only be installed by qualified
technicians. Malfunctioning due to improper
installation may cause injury or death.
3.1 GENERATOR HOUSING CHARACTERISTICS
- The generator must be installed in a sufficiently
ventilated room able to assure the small amount of air
required for engine combustion.
- The roommust be acoustically separated and isolated
from the living quarters.
- The generator must be positioned in such a way as to
facilitate normalmaintenance operations.
- It is advisable to install the generator in the
propulsion engine room provided that it meets the
above conditions.
- The air must be clean.
- The air temperature in the place of installation must be
between -5°C (23°F) and +40°C (104°F).
- The relative humidity must not exceed 50% at a
maximum temperature of +40°C (104°F). Relative
humidity of 90% at +20°C (68°F) and 100% at +25°C
(77°F) is permissible.
3.2 LIFTING
To lift the generator place the hook in the hole (ref.1)
Always take these precautiona when lifting the
generator:
- Do not swing suspended loads.
- Never leave the load unattended.
- Lower the generator to the ground very slowly.
- Always maintain the safety distance.
All the lifting operations must be carried out by
personnel specialised in this type of work, such as
truck drivers, crane drivers, slingers.
Theoperatorisconsideredresponsibleforusingthe
correctmachine slinging and lifting technique.
3.3 ANCHORING THE GENERATOR
Forfixing the generator setpredispose anadapted plinth
to sustain the weight and vibrations of the generator.
Proceed then to the perforation of the plinth following
the indications in (ref.2).
3.4 VENTILATION
Thegenerator is equipped withan internalforced cooling
systemthrough a water/air exchanger.
The amount of air required for combustion is
aspiratedthrough the intake located on the base (ref.3):
Therefore, always check that this intake is
free of any obstruction.

Mase Generators IS 6.1 Specifications

General

Brand	Mase Generators
Model	IS 6.1
Category	Portable Generator
Language	English