Mase Generators IS 6.1 User Manual

IS 6.1
- 40
GB
GB
6.16 LIST OF RECOMMENDED SPARE PARTS
Description
Seawater pump impeller
Seawater pump gasket
Seawater pump belt
Oil filter
Fuel filter
Zinc anode
Fuses
A kit with recommended spare parts is available and
may be ordered from Service Network or Technical
Service.
6.17 PERIODS OF INACTIVITY
Start up the generator at least once a month. If the
generator is not to be used for a long period of time,
carry out the following operations:
- Change the engine oil.
- Replace the oil filter cartridge (see par.6.5).
- Replace the fuel filter cartridge (see par.6.6, 6.7).
- Remove the injector and pour 2 cc of engine oil into
the cylinder and let the engine turn a few times by
manually operating the drive shaft pulley.
Refit the injector.
- Replace the zinc pads (see par.6.13)
- Aspirate some antifreeze into the seawater intake
pipe in order to protect the exchangers against low
temperatures, and lubricate the seawater pump
impeller and the metal parts in the cooling system.
- Disconnect the starter battery and store it in a dry
place (see par. 6.15)
- Disconnect the sea exhaust pipe from the engine
manifold.
- Clean the seawater filter.
- Close the seawater intake cock.
- Drain the seawater from the exhaust.
- Clean and lubricate the antisiphon valve (siphon
break), if installed.
- Clean the outside of the generator, removing all dust
and impurities.
- Cover the generator with a nylon sheet and store it
in horizontal position in a dry and ventilated place.

Mase Generators IS 6.1 Specifications

General

Brand	Mase Generators
Model	IS 6.1
Category	Portable Generator
Language	English