6.
A
Current Measurement Button
Press
A
button to measure current of the circuit and display
the measurement value in the LCD display.
7.
RS232
Data Transmit Button
Press
RS232
button to transmit measured data to a computer by
special interface cable, you can record current measured value and
print reports and data trend curve drawing.
Before press the
RS232
button to transmittal measured data, you
must connect RS232C interface cable to the clamp meter and a
computer, the communication function is working.
8.
CLEAR
Clear Memory Button
Press
CLEAR
button for three seconds to erase all measured data
in the meter memory in the measurement mode.
9. Backlight Button
Press button to turn the backlight on or off. When the back-
-light turned on over five seconds, it will turn off automatically.
10.
MAX
Maximum Value Measurement Button / Previous Record
Button
Press
MAX
button to measure maximum value in measurement
mode. The display shows current maximum value in the secondary
display.
When you turn the selector to MR, press
MAX
button to recall
previous memory location and display the data on the LCD. Once
pressing this button, the clamp meter recalls a memory location
previous current location.
11.
MIN
Minimum Value Measurement Button / Next Record Button
Press
MIN
button to measure minimum value in measurement
mode, the display shows current minimum value in the secondary
display.
– 8 –
To Next Page
Loading...
Need help?
General
