anything inside the glove box. Master-
Craft is not responsible for such damage.
Any items placed in the glove box that
cannot or should not become wet should
be placed in water-tight containers before
placing them inside the glove box.
Troubleshooting:
Any time the lid will not close and
latch properly, see an authorized Master-
Craft dealer. If it is not properly closed,
damage could occur to the lid.
Heater
Models:
All MasterCraft models offer a heat-
er option.
Purpose:
Warmed air from an electrically
powered heater box will be blown from
vents within the boat deck.
Location:
Heater vents locations vary by mod-
el, but all are located within the deck
near the oor.
Operation:
Among the accessory options avail-
able for your boat is a heater function.
The heater’s three-position switch rotary
control is turned left for ON (LOW), or
turned right for ON (HIGH). The center
position is OFF.
Excessive use will drain the
battery(ies). See the battery information
provided at the beginning of this sec-
tion of this Owner’s Manual to avoid
potentially becoming stranded by a fully
discharged battery or batteries. Pay at-
tention to the voltmeter(s); any time
the reading falls below 10.5 volts, the
battery(ies) will require recharging,
which must be done properly. That in-
formation is also contained in the begin-
ning of this section.
Special Attention:
In regular use, the heater should not
require any routine maintenance. Howev-
er, it is advisable to avoid placing items in
front of the vents, particularly when the
heater is in use. The heated air coming
out could cause damage.
Never run the heater in a conned
space, such as a garage or shop. Run-
ning the heater requires also running the
engine and fumes from the engine can
have deadly consequences. See also the
Boat Operations • 2014 MasterCraft Owners Manual Page 4-47
B O A T O P E R A T I O N S
To Next Page
Loading...
Need help?
General
