EasyManuals Logo
Home>MasterCraft>Boat>2014 X46

MasterCraft 2014 X46 User Manual

MasterCraft 2014 X46
285 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #223 background imageLoading...
Page #223 background image
Page 6-30 2014 MasterCraft Owners Manual • Care and Maintenance
C A R E A N D M A I N T E N A N C E
Note: Be sure that hoses will not be-
come entangled in the engine V-belt when
the engine turns over or the hose and/or the
belt will be damaged.
Step 5: Use duct tape to seal the exhaust
aps to prevent dirt and nesting
rodents from entering.
Step 6: On X55 boats equipped with
heads, clean the tanks with a mild
cleanerorwarmsoapywaterthat
willnotharmthenish.Avoidall
petroleum-based household clean-
ers.Storetheheaddryandclean.
Failuretodosomaycauseunnec-
essary odors and damage to the
tanks, and this is not covered un-
der warranty. If using anti-freeze
in the head, drain the potable wa-
ter tank and add freshwater anti-
freeze to the potable water tank.
Flush the anti-freeze and water
mixture through the head and
into the waste holding tank. Then
empty the holding tank. Never
useautomotive-typeanti-freezein
thisfreshwatersystem.
Step 7: Ifthetowerwillbeloweredduring
storage, be certain that the tower
does not rest on the boat uphol-
steryoronanysupportthatrests
on the upholstery. The tower or
support(s)mayleaveapermanent
imprintontheupholstery.Thisis
notcoveredunderwarranty.
Step 8: Cover the boat with a boat cover
or tarp.
Note: If the boat is to be stored out-
side and subject to accumulations of snow,
water and ice, a support should be made
for the boat cover so that it will not sag,
rip or tear, thereby allowing water to enter
the boat. Two-inch diameter PVC plumbing
pipe is ideal for this purpose. It is readily
available at local hardware stores, and it is
easy to work with. Also, its rounded shape
will prevent damage to the canvas.
Ballast System Preparations
Step 1: Attach a hose to the starboard side
ballast hose that comes out of the
deck at the rear seat.
Step 2: Place the other end into a gallon
ofnon-toxic,RV-typeanti-freeze.
Step 3: Turn the pump on to empty and
pumpanti-freezeintothesystem
until anti-freeze comes out of the
thru-hull on the side.
Step 4: Turnthepumpontollandpump
anti-freeze back into the jug.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft 2014 X46 and is the answer not in the manual?

MasterCraft 2014 X46 Specifications

General IconGeneral
BrandMasterCraft
Model2014 X46
CategoryBoat
LanguageEnglish

Related product manuals