EasyManuals Logo
Home>MasterCraft>Boat>2014 X46

MasterCraft 2014 X46 User Manual

MasterCraft 2014 X46
285 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #255 background imageLoading...
Page #255 background image
time of manufacture. Check the local and
state requirements regarding any additional
equipment that may be required.
Note: Trailer laws covering such things
as brakes, lights, safety cables, licenses,
etc., will vary from state to state. Be sure
that the trailer is in full compliance with
applicable state laws. An authorized Mas-
terCraft dealer can help in this regard. Oth-
erwise, contact the nearest state motor ve-
hicle department.
Maintenance
(Note that failure to follow these rou-
tineproceduresmayresultinfailuresthat
arenotcoveredunderwarranty.)
Failure to follow maintenance procedures
as outlined in this Owner’s Manual may re-
sult in component failure. Such failure is
not covered under warranty. Failure may
also result in loss of control or other mal-
function that could potentially lead to seri-
ous injury or death!
Hose off the brake rotors and calipers,
along with all other parts of the trailer
that have come in contact with salt water
or brackish water, as this will minimize
corrosion. A fresh water ush of the sys-
tem is the most critical aspect of trailer
maintenance.
Extremely thick, heavy rust on rotor sur-
faces will not allow the wheel assembly
to rotate freely, resulting in heat build-
up and premature wear on components.
Clean or replace components as neces-
sary.
Brake pads must be replaced when 3/32”
(.094”) or less of the pad friction mate-
rial is left.
Brake pad replacement should be per-
formed by an authorized MasterCraf
dealer. Improper pad replacement may de-
crease braking eectiveness, potentially
resulting in a collision as a result of failure
to stop the tow vehicle within an accept-
able distance.
Rotors should be resurfaced by a quali-
ed brake specialist if extreme galling or
wear marks are present.
Worn rotors must be replaced. Failure to do
so may result in brake failure, which may
cause serious injury or death.
Be certain that hydraulic uid is clean
and the uid level is within ½” of the
top of the reservoir. (See the Actuator
and Axle information contained in this
section of the Owners Manual.) Do not
ll beyond that level. Brake systems use
DOT 3 (preferred) or DOT 4 hydraulic
uid. DO NOT USE DOT 5 BRAKE
FLUID. DOT5 FLUID WILL DAM-
AGE THE SEALS IN THE ACTUA-
TOR AND CALIPERS, CAUSING
FAILURE OF THE BRAKES THAT
COULD LEAD TO INJURY OR
DEATH.
Check for leaks in the brake lines and
ttings. Leaks will lead to loss of trailer
braking ability. Present the trailer to an
authorized MasterCraft dealer for repair
Page 7-30 2014 MasterCraft Owners Manual • MasterCraft Trailers
M A S T E R C R A F T T R A I L E R S

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft 2014 X46 and is the answer not in the manual?

MasterCraft 2014 X46 Specifications

General IconGeneral
BrandMasterCraft
Model2014 X46
CategoryBoat
LanguageEnglish

Related product manuals