Boat Operations • 2014 MasterCraft Owners Manual Page 4-65
B O A T O P E R A T I O N S
Location:
The table mounts are located on the
port side of the passenger seating aft of
the observer seat.
Operation:
The table legs and tops snap into
place. The legs and tops should always
be stored in a storage compartment
when the boat is underway. If individu-
als are thrown about during operation,
they could be injured or the table and leg
could be damaged, which is not covered
under warranty.
Never leave table tops and legs on deck
during boat operation, even in designated
operational locations. Tops and legs should
always be stored in a storage compartment
when the boat is underway. People can be
injured if they make contact with the table
when the boat is moving; also the table and
leg may be damaged, which is not covered
under warranty.
Special Attention:
When stored away, the top and leg
should also be situated so that the metal
top and bottom of the leg cannot rub
against the table top and cause scratches.
This type of damage will not be covered
under warranty.
See the Cleaning the Boat section of
this Owner’s Manual for information on
cleaning the surfaces of all tables.
Troubleshooting:
If the table leg or top will not snap
into place, ensure that there are no ob-
structions. If they still will not engage,
or if they will not disengage after use,
take the boat to an authorized Master-
Craft dealer for assistance. Do not try
to force the components into or out of
place because it may result in damage
that is not covered under warranty.
To Next Page
Loading...
Need help?
General
