Matrix Vision mvHYPERION-Series - Page 131

17.5 Working with a Basler Sprint line scan color camera 127
Figure 5: wxPropView - Selecting modes
Note
With the property "Divider" you can set if every signal (or every second, third etc.) from the rotary encoder is
used.
17.4.6 int Reset()
With this function you can reset the counter, which is saved in InhibitBackwardUntilLastPos (p. 126).
17.5 Working with a Basler Sprint line scan color camera
17.5.1 Introduction
Basler's Sprint line scan color camera uses a two line sensor with a Bayer Mosaic filter mask. To use the demosaic
algorithm correctly, you have to set the
• BayerParity.
There are 4 possibilities for the BayerParity:
MATRIX VISION GmbH