Matrix ClimbMill C50-F - Page 26

24
5.4 FRONT SHROUD REPLACEMENT - CONTINUED
CHAPTER 5: PART REPLACEMENT GUIDE
8) Remove the console mast cover (Figure E).
9) Remove the 5 screws holding the console mast to the frame (Figure F).
10) Pull the console cable out of the console mast (Figure G).
11) Pull up the front shroud and remove it from frame (Figure H).
12) Reverse Steps 1-11 to install a new front shroud.
13) Test the Climb Mill for function as outlined in Section 5.19.
FIGURE E FIGURE F
FIGURE H
FIGURE G