7
3.1 CARE AND MAINTENANCE INSTRUCTION
CHAPTER 3: PREVENTIVE MAINTENANCE
MAINTENANCE SCHEDULE
ACTION FREQUENCY
Clean and inspect the ClimbMill:
• Turn off the machine with the ON/OFF switch, then unplug the power cord at the wall outlet.
• Clean entire machine using water and a mild soap applied to a soft cloth. Never use solvents, as they can
cause damage to the ClimbMill. Never spray cleaner directly onto the machine or console.
• Inspect the power cord. If the power cord is damaged, please reference contact information on the back
cover of the INFORMATION CARD for assistance.
• Make sure the power cord is not underneath the machine or in any other area where it can become pinched
or cut during storage or use.
• If any labels are damaged or illegible, please reference contact information on the INFORMATION CARD for
replacement.
BEFORE EACH USE
Clean underneath the machine:
• Turn off the machine with the ON/OFF switch, then
• unplug the power cord at the wall outlet.
• Remove the debris tray from under the machine by sliding it out from the right side and wipe or vacuum any
grease, dust particles or other objects that may have accumulated on it. Return the debris tray to its previous
position.
• Wipe or vacuum any dust particles or other objects that may have accumulated around the machine.
WEEKLY
Unplug the ClimbMill and clean the AUTO STOP SENSORS (located under the bottom step). WEEKLY
IMPORTANT!
• Turn off the machine with the ON/OFF switch, then unplug the power cord at the wall outlet. Wait 60
seconds.
• Inspect all assembly bolts of the machine for proper tightness. Reference assembly steps for proper tension
of each bolt.
• Remove the front access cover. Wait until ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may have accumulated.
Failure to do so may result in premature failure of key electrical components.
• Check step motion by rotating the steps backwards to ensure free movement.
• Check stability to ensure the ClimbMill does not rock or wobble. Adjust levelers as necessary.
MONTHLY
AUTO STOP SENSORS
To Next Page
Loading...
Need help?
General
