29
5.8 HANDGRIP SERVICE
CHAPTER 5: PART REPLACEMENT GUIDE
1) Turn off the power and disconnect the cord from the machine.
2) All items on the handlebar are removed using a Phillips screwdriver from the underside of the bar.
3) Once the screws are removed, lift the part carefully then disconnect any wire connections to fully remove the part. This includes the handgrip
cover (Figures A & B).
4) Remove the handgrip from handlebar (Figure C).
5) Reverse Steps 1-4 to install a new handgrip. NOTE: Before assembling the quick key cover, push the grip cable back to handgrip rst
(Figure D) to prevent cable injury.
6) Test the Climb Mill for function as outlined in Section 5.19.
FIGURE A FIGURE B
FIGURE C
To Next Page
Loading...
