44
5.19 TESTING THE CLIMB MILL
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) To enter Engineering Mode, input the serial number of the console and frame. Also set the Machine Type and verify that the Date and Time
are correct.
2) Press the GO key and begin using the machine. Stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
3) Grasp the hand grips to check for proper heart rate response.
4) Press the LEVEL UP and LEVEL DOWN keys from hand grip to make sure resistance is fully functional.
5) Try stepping off the unit to make sure the proximity sensor is fully functional. Also test the STOP key on the grip, IR sensor, Control Zone and
Emergency Stop key (on console mast and lower handlebar) for function. .
CHAPTER 5: PART REPLACEMENT GUIDE
To Next Page
Loading...
Need help?
General
