Matrix ClimbMill C50-F - Front Shroud Replacement

23
5.4 FRONT SHROUD REPLACEMENT
1) Turn off power and disconnect the cord from the machine.
2) Remove the service cover as outlined in Section 5.1.
3) Remove the side covers as outlined in Section 5.2.
4) Remove the console as outlined in Section 5.3.
5) Remove the 4 screws holding the front cover to frame (Figure A & B).
6) Remove the 2 screws holding the handlebar to the console mast (Figure C).
7) Disconnect the E-stop wire connector at the bottom of the console mast (Figure D).
FIGURE D
FIGURE B
FIGURE C
FIGURE A
CHAPTER 5: PART REPLACEMENT GUIDE