Matrix ClimbMill C50-F - Page 38

36
CHAPTER 5: PART REPLACEMENT GUIDE
5.12 CHAIN REPLACEMENT - CONTINUED
8) Remove the the join link (Figure G).
9) The chain can now be removed.
10) Reverse Steps 1-9 to install a new chain. When installing a new chain, it is important to pay attention to the join plates. The join plates are
widerthanthechainitself.Itisimportantthatthesideofthejoinplatesthatareushwiththerestofthechaingetinstalledtotheinsideofthe
chain path (Figures H & I).
11) Test the Climb Mill for function as outlined in Section 5.19.
FIGURE G
FIGURE H FIGURE I