Matrix ETERNITY NE Quick Start Guide

Matrix ETERNITY NE Quick Start 5
Installing Optional Modules
GSM/UMTS Module
• Unpack the GSM/UMTS Module and verify package contents.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the
cover aside.
• Select the Mobile port you want to install the GSM/UMTS module.
• Remove the screws on the studs and keep them aside.
• The slots for the GSM/UMTS module are located on the side panel and are
covered with a flap. Use your finger or any blunt object to press the slot cover
from the outside of the panel to release the flap.
• Now, grasp the flap from inside the enclosure and pull up the flap.
• Gently seat the GSM/UMTS module on the connector on the mainboard such
that the SIM holder and the antenna connector emerge from the respective
slots. The connector pins on the module must make complete contact with those
on the mainboard. Do not apply pressure.
• When the module is seated firmly on the connector on the mainboard, secure
the module with the screws on the studs.
• If you have no other module(s) to install, replace the top cover and secure the
cover with the screws.
VoIP Module
• Unpack the VoIP module and verify package contents.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the
cover aside.

Matrix ETERNITY NE Specifications

General

Brand	Matrix
Model	ETERNITY NE
Category	PBX
Language	English