Matrix ETERNITY NE Quick Start Guide

6 Matrix ETERNITY NE Quick Start
• Locate the connector of the VoIP module on the mainboard. Remove the screws
on the studs for the module and keep them aside.
• Gently seat the VoIP module on the connector on the mainboard. The connector
pins on the module must make complete contact with those on the mainboard.
Do not apply pressure.
• When the module is seated firmly on the connector on the mainboard, secure
the module with the screws on the studs.
• If you have no other module(s) to install, replace the top cover and secure the
cover with the screws.
Voice Mail System Module
• The Voice Mail System (VMS) module is supplied as a Pen Drive, with a License
Voucher which you must activate to use the module. Unpack the Voice Mail
System module and verify package contents.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the
cover aside.
• Locate the USB port on the the mainboard. Connect the Pen Drive to the upper
USB port on the mainboard.
• If you have no other module(s) to install, replace the top cover and secure the
cover with the screws.
• Activate the License for the VMS. See “Activating License Key” under
Configuring ETERNITY NE for instructions.
Door Phone Module
• Unpack the Door Phone module and verify package contents.
• Make sure power supply is turned off before you begin installation.
• Unscrew and remove the top cover of the enclosure. Keep the screws and the
cover aside.

Matrix ETERNITY NE Specifications

General

Brand	Matrix
Model	ETERNITY NE
Category	PBX
Language	English