12 Matrix ETERNITY NE Quick Start
• Use standard twisted wire pair cables of good quality with RJ11 plugs to connect
the DKP(s).
To connect EON48,
• Place the EON48 at the desired location.
• Connect the handset of EON48 to the phone body using the spring cord
supplied with the phone.
• Connect EON48 to the wall jack. Plug one end of the RJ11 cable into the
connector of
EON48 labeled as ‘Line’. Plug the other end into the wall jack.
• To connect EON48 to ETERNITY, plug the RJ11 end of the telephone cable into
the DKP port of ETERNITY NE and terminate the other end of the telephone
cable from the DKP port on the wall jack.
To connect DSS64 to EON48,
• Place DSS64 next to EON48.
• Connect DSS64 to the wall jack. Plug the RJ11 end of the telephone cable into
the connector on DSS64. Plug the other end into the wall jack.
• To connect DSS64 to ETERNITY, plug the RJ11 end of the telephone cable into
a DKP port of ETERNITY and terminate the other end of the cable from the DKP
port on the wall jack.
To connect EONSOFT,
• Plug the RJ11 end of a telephone cable into the DKP port of ETERNITY NE.
Terminate the other end from the DPK port on the wall jack.
• Plug the RJ11 end of a second cable into the connector labeled as ‘DKP’ on the
dongle of EONSOFT. Plug the other end into the wall jack.
For detailed instructions on installing EONSOFT, refer the System Manual.