13
Matrox Monarch HDX hardware
Switch to Static IP mode
You can switch your Monarch HDX device to Static IP mode by pressing the
ENCD 2 button while the Encoder 2 LED flashes during the power-up sequence.
1 Press the Reset button on the device to initiate a device reboot. During the
power-up sequence (see “Powering Monarch HDX” on page 11), the
Encoder 2 LED flashes for three seconds.
2 Press the ENCD 2 button on the device while the Encoder 2 LED is flashing.
This sets the device to Static IP mode and the Static IP address to its default
address (169.254.1.11).
The device is ready when the Warning ( ) LED stops flashing; however, the
Warning LED ( ) may remain on if there is an error condition (see “Status
page” on page 23 for more information).
Reset to factory defaults
When resetting Monarch HDX using this method, all Monarch HDX settings
reset to factory defaults, the device password resets to admin, and the device
powers up in DHCP IP mode for connecting to a network with a DHCP server,
such as a router. To switch the device to Static IP mode after performing a factory
reset, see “Switch to Static IP mode” on page 13.
To reset Monarch HDX to factory defaults, press and hold the Reset button on the
device for at least five seconds. The device begins a power-up sequence during
which various LEDs will flash on and off. The Warning ( ) LED will begin to
flash early during the boot up sequence, and once it stops flashing, the Monarch
HDX is ready for use.
The Warning LED ( ) may remain on if there is an error condition (see “Status
page” on page 23 for more information.
To Next Page
Loading...
