39
Device page
Device name and password
By default, the device name is set to Monarch HDX. You can give a unique name
to each Monarch HDX device for easy identification within the Command Center
and the Matrox Monarch HDX Utils (see “Monarch HDX Utils application” on
page 16). This is especially useful when you have multiple Monarch HDX
devices on the same network. To change the name of your Monarch HDX, type
the desired name in the
Device name box, and then click Change.
Username and password
A username and password are required to access the options and features of the
Device page.
By default, the Monarch HDX username and password are set to admin. The
device username cannot be changed, however, we do suggest that you change the
device password. To change the Monarch HDX password, enter the current and
new passwords and then click
Change. For information on resetting the
password to factory default, see “Reset to factory defaults” on page 13.
IP Setup tab
The IP Setup tab in the Command Center lets you switch the Monarch HDX IP
mode between DHCP and Static. By default, Monarch HDX is set to DHCP
mode.
¡ Important Changing the IP mode will end the current Command Center
session. To access the Monarch HDX Command Center again via IP address, you
will need to enter a different Monarch HDX IP address in your browser’s address
field. If switching to Static mode, you may also be required to change your
computer’s network configuration. For information on obtaining the Monarch
HDX IP address and accessing the Command Center in DHCP or Static mode,
see Chapter 3, “Network Connection and Setup”.
To access the
IP Setup tab, open the Monarch HDX Command Center, and then
choose
Device > IP Setup.
To Next Page
Loading...
