9
Matrox Monarch HDX hardware
LAN
The LAN port is an auto-sensing 10/100/1000 Base-T Ethernet port used to
connect Monarch HDX to an Ethernet network via a standard RJ-45 Ethernet
cable. For information on how to connect to a network, see Chapter 3, “Network
Connection and Setup.”
RS-232
The RS-232 port is currently for internal use only.
Video/audio inputs and outputs
Matrox Monarch HDX supports both SD (SDI only) and HD video signals, and
auto-detects input source information; however, it does not support upscaling the
input source for streaming or recording.
HDMI out
Provides a preview of the selected SDI or HDMI input. For audio, you have the
following options:
• Use the first pair of embedded HDMI audio channels.
• Use the first pair of embedded SDI audio channels.
• Use the analog pair.
¦NoteFor more information, see “Audio Input Settings” on page 26.
To display your input source, your monitor must support the input resolution. If
your monitor does not, an error message will appear. For supported resolutions,
see “HDMI in” and “SDI in”.
¦NoteWhile SD resolutions are not supported, if the SDI input is in SD, the
HDMI output will be a “windowboxed” version of the picture in an HD output.
HDMI in
Provides an input for HD HDMI video (YUV or RGB) from a digital HDMI
device for streaming and recording. The HDMI input supports the following
video input formats:
• 1920 × 1080p at 23.98/24/25/29.97/30/50/59.94/60 fps
• 1920 ×1080i at 25/29.97 fps
• 1280 × 720p at 50/59.94/60 fps
• 720 × 576p at 50 fps
• 720 × 480p at 59.94 fps
Monarch HDX supports the first two channels of uncompressed embedded audio
from the HDMI input source for streaming and recording. HDCP and SD sources
are not supported on this input. You can monitor the HDMI input source by
To Next Page
Loading...
