Matrox Monarch HDX - Device Page; Control Tab

36
Chapter 4, Using the Command Center
When entering the path and filename, you must enter the IP address of the
location on the network to which you want to record, followed by the full
path to the shared folder from the root directory, and then the base name
for the file in the following format:
//IP address:/full path to shared folder/basename
For example, if you want to name your file Recording1 and save the file to
a shared folder named Files that is located on the Desktop under Matrox
in the Users root directory folder on a network computer with an IP
address of 123.456.7.890, enter the following:
//123.456.7.890:/Users/Matrox/Desktop/Files/Recording1
¥Tip You can obtain the full path to the shared folder by right-clicking
the folder, and then clicking
Get Info.
Domain, username, and password
When recording your source input to a network location (see “Media” on
page 34) and Monarch HDX is not on the same domain as the network, enter the
network domain. If required, also enter the
Username and Password that is
used to access the network.
Device page
The Device page is where you access various settings related to all aspects of the
Monarch HDX and its operation. You access these settings by clicking the tabs at
the top of the Command Center page.
Control tab
The Control tab lets you control the streaming and recording for your Monarch
HDX device, and up to four other Monarch HDX devices connected on the same
network. You can also use the encoder buttons on a Monarch HDX device to
stream and record for that device, but you cannot control other devices with the
encoder buttons. For more information, see “Encoder buttons (ENCD 1 and
ENCD 2)” on page 7.
To access the
Control tab, open the Monarch HDX Command Center (see
“Accessing the Command Center” on page 19), and then click
Control.