Matrox Monarch HDX - Streaming and Recording Errors; Fan and Temperature Errors; Input Settings

25
Input Settings
Streaming and recording errors
Streaming and recording errors that don't appear as a pop up error on the
Control
tab are instantly logged in the
Messages section of the Status page. Clicking
the
Clear messages button on the Status page deletes the logged error from the
list and the Warning LED turns off. The Warning LED will also turn off if you
successfully start a new stream and/or recording.
¦NotePowering off or resetting Monarch HDX will clear streaming and
recording errors from the device.
Fan and Temperature errors
The fan is located under the device, and a constant readout of both the fan and the
temperature statuses appear above the
Messages section of the Status page. A
fan or temperature error will be indicated in this area as well. No fan or
temperature-related error message will be shown in the
Messages section.
¡ Important This error won't stop the device; however, we recommend that you
address the issue as soon as possible.
The display reads “Normal” for the fan and temperature when the fan is operating
without a problem. If a fan and/or temperature error occurs, the status will change
to “Faulty” and/or “Critical”. The error status will remain as long as a problem is
detected and has not been resolved. The Warning LED will turn off when the
condition is corrected, and the
Status page will automatically update the
fan/temperature status back to Normal.
The temperature may come down on its own over time, and so the Warning LED
will turn off and the fan and temperature statuses will return to Normal; however,
the Warning LED will light up again and the error status will display if/when the
temperature rises once more.
The fan operates as an uptake under the device. For good fan operation, ensure
that the device is not placed on top of paper, and that it used in an area with
adequate air circulation. If a fan or temperature error occurs:
• Check that the fan is spinning and is unobstructed.
• Verify that the area has suitable sufficient ventilation and that the ambient
temperature has not risen.
Input Settings
The Input Settings page in the Command Center lets you set the video and
audio input sources used for streaming and recording.When controlling multiple
devices, each device on the network streams and records the video and audio
based on its individual settings.